- Fold a piece of Poppy parade CS in 2 to create your card base
- Using the foliage from the Vintage Vogue stamp set, stamp it at the top of your card front in Poppy Parade ink
- Glue down your 3 3/4" x 4 1/2" piece of DSP to your front
- Take a piece of 4" x 1" of Whisper White CS and punch the edge with the Eyelet Border Punch
- Take a 4 1/2" long piece of Daffodil Delight 3/8" wide Taffeta Ribbon and glue the ends to the back of that Eyelet strip.
- Adhere those 2 at the top of your DSP (as seen in the picture)
- Mat a piece of 2 1/4" x 3 1/8" of DSP on a 2 1/2"x 3 3/8" piece of Daffodil Delight, stick them at 3/8" from the bottom and right side of your already glued down DSP
- On your 2"x2" piece of Whisper white, Stamp the F in Poppy parade classic ink and the little vine in Daffodil Delight
- Mat this last piece onto a 2 1/4" x 2 1/4" of Poppy parade and adhere those ones on your card front (build it up)
- stamp the 'You raise kindness to an art." sentiment in black ink onto a scrap piece of Whisper white then trim it down to 5/16" x 2 1/4"
- Glue this piece onto a 7/16" x 2 3/8" of Daffodil Delight CS
- Glue the sentiment down using 2 dimensionals (one at each end)
- ON a scrap piece of Whisper WHite CS, stamp in Peach Parfait; 2 little flowers... in Poppy Parade; 1 big flower, in Daffodil Delight; 1 little flower and in Pear Pizzazz; 5 leaves
- Using your paper snips, make sure to only cut the cardstock (and leave your fingers out of the blades way... trust me, it hurts, lol)
- Now, build your flowers as seen in the picture above and stick them down with dimensionals
- and to finish all of this off, add a few Pearls from the Pearls Basic Jewels... Done
Friday, 18 February 2011
February Stamp a Stack... Michelle Warford inspired!
Hurray for paper snips and layers, lol!!!!
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment